Engraving Time Calculator

Calculate the engraving time for your job on your eurolaser system

This calculator is a helpful tool to estimate the time needed for your engraving job as a basis for a quotation or to optimize the utilization of your capacities.

 

Step by step instructions

1. Please select your eurolaser system that you would like to use for the engraving.

2.  Please indicate the size of your engraving area
and enter the X and Y lengths (see picture below).
Tip: Y value should be higher than X to speed up the engraving time.
 
3. Please select the resolution for your engraving in dpi.

 

4.  In the yellow field below your entries you find the estimated engraving time.
Estimated engraving time (hh:mm:ss)

0


5.  The calculated optimum speed is 0 mm/s.
To optimise the engraving time for the given values, please enter this parameter in your "Raster Speed" settings of your LaserScout software.

6.  For the specified engraving size you need at least 0 mm space (D) in Y direction for acceleration and deceleration. Please consider this value when placing your workpiece.

 

Please note:
This is a theoretical calculation of the engraving time of a rectangular geometry. The actual time for other shapes is less because lines without black / grey pixels are completely skipped and the system runs faster.

 
© 1994 -2022 eurolaser GmbH. All rights reserved.


Cookie settings