Laser cutting of sealing material

Klingersil C-4400 – accurately sealed

Seals are usually exposed to highly complex demands. Their functionality therefore depends on a number of parameters. Ever increasing environmental and safety consciousness leads to higher and higher demands on sealing capability. It is self evident that an accurate, well fitting blank is a prerequisite for the seal's effectiveness. The CO2 laser provides the ideal solution.

What are the benefits of cutting seals with laser?

  • Very high precision and repeat accuracy
  • Non-contact cutting means no application of force and therefore no stretching of the material
  • Radius-free internal contours possible
  • No tools (punches, cutters), therefore no wear
  • Less cleaning required due to reduced dust formation during cutting

In our example, the sealing material consists of aramid fibres bonded with nitrile butadiene rubber. The material thickness is 0.5 mm.

More about laser cutting of sealing material

In our example, the sealing material consists of aramid fibres bonded with nitrile butadiene rubber. The material thickness is 0.5 mm.

More about laser cutting of sealing material

Typical applications of Klingersil C-4400:

  • Fuels, oils
  • Water, steam, gases
  • Lubricants, coolants
  • Hydrocarbons
  • Saline solution
  • Weak organic and inorganic acids

We recommend the following laser systems for the cutting of standard plates of Klingersil C-4400:

Do you have any questions? We are pleased to advise you.

or please call for your individual consulting!

+421 43 422 47 48

+49 4131 9697 500

 
© 1994 -2022 eurolaser GmbH. All rights reserved.


Cookie settings