Big, bigger, engraving up to 10 square meter

Pictures, logos, labels and much more - engraving and marking on various material surfaces.
This is an impressive option!

Laser engraving and marking with a CO2 laser

  • Output of picture files as pixel graphics on the complete working area (up to 3200x2910mm)
  • Vector engraving, raster engraving and vector cutting in one single processing step
  • Using without tool changing
  • No swarf
  • The high quality and output of the 'normal' cutting applications remain unaffected.
  • Material does not have to be clamped
  • Abrasion-proof, resistant
  • Available for all systems built after 1st March 2001, setup by our service technicians

The principle is simple. The application brilliant. The result more than precise.

Along with 10 other formats, eurolaser also markets the world's largest laser engraving machine.

The principle is similar to that of an inkjet printer. The concentrated laser beam is responsible for a possible change in surface contrast and therefore for generating an image in the form of a slight surface relief.

Pixel laser engravings enhance the possibilities of

  • Product identification
  • Protection against fakes
  • Identification
  • Individualisation

Image mode

Black-and-white pictures between 75 and 300 dpi with excellent contrast can be produced in 1-bit mode and require a relatively short process time depending on the template and material.

Calculate your engraving time

In 8-bit mode, you can produce a photo-quality image up to 1,200 dpi using grey scale templates or generate a deep engraving for a relief. 


  • Resolution: maximum resolution of 75dpi - 1,200dpi
  • Working speed: from 200 to 1,000 mm/s
  • Travel speed: maximum accelaration of 7,5 m/s².
  • Requirements: retrofit on all systems from 1st March 2001
  • Scope of delivery: hardware-set and LaserScout Software

Typical and suitable materials are:

Do you have any questions? We are pleased to advise you.

© 1994 -2024 eurolaser GmbH. All rights reserved.